Controlling MXNet with Control4

How To: Controlling MXNet with Control4

MXNet is designed to work with control systems such as Control4. Take a look at what you can do with Control4 to connect and control the MXNet Ecosystem. 



For detailed Control4 driver configuration steps please see our Off-Site Pre-Commission and On-Site Installation driver setup guides. 

    • Related Articles

    • How To: Using the MXNET API ~ V1.21.1

      Kevin Wang, Director of Product Management, goes through using the MXNET API to control and configure the MXNet CBOX Direct. Current API Version: V1.21.1 Control Box Version: 2.71 and above Instructions and API attached

    • Third-party Switch Requirements and Settings for Running AVPro Edge MXNET AVoIP System

      Third-party Switch Requirements and Settings for Running AVPro MXNET AVOIP System Third-party network switches must support the following features and functionalities and enable or disable some settings in order to support the AVPro MXNET AV-over-IP ...

    • How To: Using the MXNet USB Control Tool

      Powerpoint and software for the USB Control Tool used when configuring Point To Point, Multicast Settings, and Control Routing.

    • MXNet Ecosystem Training

      Dolby Vision Support, Dolby Atmos Downmixing Support, Quick Switching, endless sources routed to endless displays; Welcome to MXNet. Join Tom and John from AVPro as they give integrators an introduction to the AV over IP/Networked AV system called ...

    • MXNet Network Switches - Basic Operation Configuration Guide

      This article provides a comprehensive overview of basic diagnostic and configuration commands for MXNet network switches, including instructions for making the necessary physical connections. The switches covered in this article are operating on ...