[Control4] AC-MXNET 10G SDVoE Driver
Control System: Control4
Version: 108
Release Date: 26 FEB 2024
Supported Products:
- AC-MXNET-10G-CBOX
Changelog:
v108:
- Performance enhancements for the multiview/tiler driver
v107:
- Fixed interpretation of video resolution data for MXnet system
- Avoid user-selected tiler output resolution from being overwritten
- Fixed Video path disable and audio path disable when turning off a room
v105:
- Added support for tiling on 10G receivers
v104:
- Initial Release
- Bidirectional serial connections
- Combined audio/video switch
- Mosaic Video Wall command
- 10G release
- Update video wall to use vwid commands
BUG FIXES
- Fix to allow case-insensitive MAC addresses in devicelist
Related Articles
How To: Using the MXNet USB Control Tool
Powerpoint and software for the USB Control Tool used when configuring Point To Point, Multicast Settings, and Control Routing.
How To: Using the MXNET API ~ V1.19.1
Kevin Wang, Director of Product Management, goes through using the MXNET API to control and configure the MXNet CBOX Direct. Current API Version: V1.19.1 Control Box Version: 2.55 and above Instructions and API attached
AC-MXNET-10G-CBOX ~ V3.40 ~ 4/24/24
Note: Please update your CBOX first before updating your TCVRs. V3.40 Bug Fixes and Improvements Fixed an issue where certain diagnostic information would continuously populate in the system log (such as "GET MODELNAME" queries). Resolved certain ...
AC-MXNET-SW48 Application Diagram
AVPro Edge is committed to reducing our carbon footprint; Application Diagram(s) are Provided on the Attached PDF.
MXNet Control4: Initial Driver Setup - Janus - Off-Site Pre-Commission
The following guide can be used to configure the MXNet driver within Control4. This guide requires the use of our MXNet driver version 12 or greater. You can find the latest version of the driver here. This guide is intended for an MXNet installation ...