AC-MXNET-10G-TCVR-USBX Firmware

AC-MXNET-10G-TCVR-USBX-B Firmware ~ V1.45 ~ 3/7/2025

NOTE: If your AC-MXNET-10G-TCVR-USBX-B is not selectable to update in MENTOR, please see this Knowledge Base Article to determine what firmware you need to upload: https://support.avproedge.com/portal/en/kb/articles/how-to-determine-the-appropriate-10g-tcvr-firmware-to-load-onto-your-device

V1.45
  1.       Added the ability to upgrade integrated modules over the network.
  2.       Added HDCP Pass-through (decoder) as well as HDCP input request options (encoder). 
  3.       Fixed an issue where disabling extracted audio output on a decoder while simultaneously lowering the volume to 0 would result in extracted audio being outputted on the decoder.
  4.       Added the ability to change the extracted audio processor's operational mode from normal operation("0") to option "1", which delays extracted audio processing by 7 seconds upon a hot plug event.
    1. This is used to mitigate a specific issue where certain sources would lose extracted audio but HDMI audio output was still present after a timeframe of 12-48 hours.
    2. Use the CBOX command "config set device dspmode" to adjust. 
  5.       Various minor improvements in relation to extracted audio. 
V1.34
  1.       Added the ability to upgrade integrated modules via USB. No other changes compared to V1.33.
V1.33
  1.       Various Bugfixes and Improvements.
  2.       Improved synchronization with HDCP-enabled content.
  3.       Further improvements with syncing with various audio formats, such as Dolby ATMOS/Dolby Digital 5.1.
V1.29
  1.       Improved synchronization with Dolby audio formats.
  2.       Initial release of -B hardware revision. Added support for USB5V Control.