Applies to:
AC-EX40-444-PLUS-T2 (Transmitter)
Note: Double-check the model number on your extender matches with the one listed above--if they
do not match, please contact AVPro Edge Tech Support to assist in troubleshooting your extender.
Model Revisions:
AC-EX40-444-PLUS-T2-A (Transmitter rev. A)
AC-EX40-444-PLUS-T2-B (Transmitter rev. B)
IMPORTANT: This extender has two model revisions, rev. A and B. Model B adds 5V Control to the
USB Ports, all other features function identically.
Different firmware is required to run each model. The Uploader software will detect the model
revision and automatically load the correct firmware file for your extender's model revision.
See attachments at the bottom of this page for the latest firmware file and Uploader software.
Please note that the update may take up to 30 minutes to complete.
CHANGE LOG
FWM Version: 2.02.00.00
Date: 4/10/2023
Enhancements:
- (rev. B and above) New model revision adds USB device 5V control
Bug Fixes:
- Resolved CEC Passthrough
- Added API Commands:
SET HP OUT 5V MODEx
{x=[1,2](1=HDMI Output 5V Always High, 2=HDMI Output 5V Follows
Transmitter 5V Input)
GET HP OUT 5V MODE
Get HDMI Port Out 5V Mode
SET USB MODEx (model
rev. B only)
{x=[1,2](1=USB Device 5V Always On, 2=USB Device 5V Follows
Host Input)
GET USB MODE (model rev.
B only)
Get USB Device 5V Mode
FWM Version: 2.02.00.00
Date: 4/10/2023
Enhancements:
- (rev. B and above) New model revision adds USB device 5V control
Bug Fixes:
- Resolved CEC Passthrough
- Added API Commands: