How To's
MV-41 & MXNet Binding Guide with Control 4
Control4 Bindings with the AVPro MV-41 and MXnet Introduction This document outlines the steps for creating Control4 bindings with the AVPro MV-41. Requirements Control4 Controller (e.g., EA-1, EA-3, EA-5, or CA-1) AVPro MV-41 Matrix Switcher ...
MXNet Control4: Videowall Setup Guide
The following guide can be used to configure the MXNet driver within Control4. This guide requires the use of our MXNet driver version 12 or greater. You can find the latest version of the driver here. This guide is intended for an MXNet installation ...
MXNet Control4: Incorrect Encoder/Decoder Assignment Correction
If one or more encoder(s) or decoder(s) were installed in the incorrect locations, and the video switching events are switching the incorrect output, the encoder(s)/decoder(s) need to be swapped in the Control4 driver. This guide will show you the ...
MXNet Control4: Initial Driver Setup - Janus - Off-Site Pre-Commission
The following guide can be used to configure the MXNet driver within Control4. This guide requires the use of our MXNet driver version 12 or greater. You can find the latest version of the driver here. This guide is intended for an MXNet installation ...
MXNet Control4: Initial Driver Setup - On-Site Installation
The following guide can be used to configure the MXNet driver within Control4. This guide requires the use of our MXNet driver version 12 or greater. You can find the latest version of the driver here. This guide is intended for an MXNet installation ...
RS232 Extension using Control4 and the AVPro Edge HDBaseT Matrix
There are two ways of using the AVPro Edge HDBaseT and Control4 for RS232 Extension. 1. Simple RS232 Extension - I want to extend an RS232 Signal from a Control Processor This is the most basic way of extending a duplex (two-way) RS232 signal from a ...
Audio Bindings using Control4 and the AVPro Edge AC-MX-??(HDBT), AXION, or Legacy Matrix
There are three ways of using the AVPro Edge Matrix in conjunction with a C4 Control System for Audio Distribution: 1. Bind to Input - I am using with another Audio Matrix (i.e. Triad AMS8) Under the System Design tab, Set the Matrix Driver Audio ...
How To: Controlling MXNet with Control4
MXNet is designed to work with control systems such as Control4. Take a look at what you can do with Control4 to connect and control the MXNet Ecosystem. For detailed Control4 driver configuration steps please see our Off-Site Pre-Commission ...