How To: Using the MXNET API

How To: Using the MXNET API ~ V1.14

Kevin Wang, Director of Product Management, goes through using the MXNET API to control and configure the MXNet CBOX Direct.

Current API Version: V1.14
Control Box Version: 1.70 and above
Presentation and API Attached
    • Related Articles

    • AC-MXNET-CBOX ~ V1.97 ~ 08/10/2022

      Note: Using firmware v1.97 for the AC-MXNET-CBOX requires the following:       All AC-MXNET-1G-R or AC-MXNET-1G-D Receivers/Decoders must be updated to v3.30 or 4.17.       All AC-MXNET-1G-T or AC-MXNET-1G-E Transmitters/Encoders must be updated to ...
    • How To: Using the MXNet USB Control Tool

      Powerpoint and software for the USB Control Tool used when configuring Point To Point, Multicast Settings, and Control Routing.
    • MXNet Control4: Initial Driver Setup - Janus - Off-Site Pre-Commission

      The following guide can be used to configure the MXNet driver within Control4. This guide requires the use of our MXNet driver version 12 or greater. You can find the latest version of the driver here. This guide is intended for an MXNet installation ...
    • AC-MXNET-CBOX Manual

      AVPro Edge is committed to reducing our carbon footprint; Click the Link Below for an Up to Date Manual:
    • AC-MXNET-CBOX Specification