How To: MXNet Point to Point Setup
This presentation demonstrates how to setup point to point extension with an MXNet Encoder and Decoder.
MXNet AVoIP are a great solution in installations where the Category Cabling cannot meet the demand of HDBaseT.
Brought to you by Kevin Wang, Director of Product Management.
Related Articles
How To: MXNet DHCP & Custom Image/Logo Setup
In this presentation Kevin Wang, Director of Product Management, demonstrates new features presented in the MXNet Ecosystem. DHCP Mode To meet the commercial market requirements, the MXNET system supports the DHCP mode, which means all MXNET ...
MXNet Control4: Videowall Setup Guide
The following guide can be used to configure the MXNet driver within Control4. This guide requires the use of our MXNet driver version 12 or greater. You can find the latest version of the driver here. This guide is intended for an MXNet installation ...
MXNet Control4: Initial Driver Setup - Janus - Off-Site Pre-Commission
The following guide can be used to configure the MXNet driver within Control4. This guide requires the use of our MXNet driver version 12 or greater. You can find the latest version of the driver here. This guide is intended for an MXNet installation ...
AC-MXNET-CBOX ~ V2.55 ~ 09/08/2023
Note: Using firmware V2.55 for the CBOX requires the following in order for RS-232 communication to function properly: AC-MXNET-1G-D Decoders must be updated to V4.25/V4.28. AC-MXNET-1G-E Encoders must be updated to V3.44. AC-MXNET-1G-EWP Wall Plate ...
How To: Using the MXNET API ~ V1.19.1
Kevin Wang, Director of Product Management, goes through using the MXNET API to control and configure the MXNet CBOX Direct. Current API Version: V1.19.1 Control Box Version: 2.55 and above Instructions and API attached