AC-MXNET-1G-EWP ~ (WALL PLATE) Firmware

AC-MXNET-1G-EWP ~ (V1 WALL PLATE) ~ V1.11 ~ 4/5/24

V1.11
  1. Added HDCP Do not Request option.
V1.10
  1. Fixed an issue where MCU commands could bleed out of the RS-232 port of the endpoint. 
  2. Added a 2ch audio description for the 1920x1200 EDID.
V1.08
  1. Adjusted the video signal input tolerance levels, to fix certain input devices not being able to pass a signal through, such as PTZ cameras/cable boxes. 

V1.04
  1. Introductory firmware release for MXNET 1G Wall Plate.

    • Related Articles

    • AC-MXNET-CBOX ~ V2.70 ~ 4/5/24

      NOTICE: If your CBOX is reading firmware as a version of V4.XX, please navigate to this page here: https://support.avproedge.com/portal/en/kb/articles/ac-mxnet-cbox-b-firmware Note: Please update the CBOX first, before attempting updates on the ...

    • How To: Using the MXNET API ~ V1.19.1

      Kevin Wang, Director of Product Management, goes through using the MXNET API to control and configure the MXNet CBOX Direct. Current API Version: V1.19.1 Control Box Version: 2.55 and above Instructions and API attached

    • How To: Using the MXNet USB Control Tool

      Powerpoint and software for the USB Control Tool used when configuring Point To Point, Multicast Settings, and Control Routing.

    • AC-MXNET-10G-TCVR, TCVR-PRO, TCVR-AVDM, TCVR-USBX Firmware ~V1.26 ~ 1/29/2024

      NOTE: All TCVR models, the base AC-MXNET-10G-TCVR, AC-MXNET-10G-TCVR-PRO, AC-MXNET-10G-TCVR-USBX, and AC-MXNET-10G-TCVR-AVDM share the same firmware. NOTE: Please Update your AC-MXNET-10G-CBOX first before proceeding with updating the firmware on ...

    • MXNet Control4: Videowall Setup Guide

      The following guide can be used to configure the MXNet driver within Control4. This guide requires the use of our MXNet driver version 12 or greater. You can find the latest version of the driver here. This guide is intended for an MXNet installation ...