AC-MXNET-1G-EV2-B ~ V2.04 ~ 09/08/23
NOTICE: Please update the CBOX first before attempting an update on any endpoints.
Release Notes:
V2.04
- Fixed an issue where MCU commands could bleed out of the RS-232 port of the endpoint.
- Added a 2ch audio description for the 1920x1200 EDID.
V2.02
- New Feature: Ability to adjust HDCP request parameters, parameters are "AUTO (HDCP 2.2) or "Do Not Request HDCP". Can be adjusted via the CBOX. Default setting is "AUTO (HDCP 2.2)".
- Fixed an issue where the USER EDID read pull from the CBOX would not display the stored EDID information on V2-B Encoders.
V2.00
- Initial launch of EV2-B firmware. Firmware is distinguished from previous hardware revision by using firmware versions V2.XX.
- Fixed a bug where additional data is returned when sending RS232 data to a device through the CBOX.
Related Articles
AC-MXNET-10G-TCVR-PRO-B Firmware ~ V1.33 ~ 4/24/2024
NOTE: If your AC-MXNET-10G-TCVR-PRO-B is not selectable to update in MENTOR, please see this Knowledge Base Article to determine what firmware you need to upload: ...
AC-MXNET-10G-TCVR-B Firmware ~ V1.33 ~ 4/24/2024
NOTE: If your AC-MXNET-10G-TCVR-B is not selectable to update in MENTOR, please see this Knowledge Base Article to determine what firmware you need to upload: ...
AC-MXNET-1G-DV2-B ~ V2.02 ~ 09/08/23
NOTICE: Please update the CBOX first before attempting an update on any endpoints. AC-MXNET-1G-DV2-B Firmware V2.02 requires CBOX firmware V2.55 or later, or CBOX-B firmware V4.09 or later, in order for RS-232 communication to function properly. ...
AC-MXNET-CBOX-B ~ V4.18 ~ 4/5/24
NOTE: If your CBOX is reading firmware with a version number of V2.XX, please navigate to this page here: https://support.avproedge.com/portal/en/kb/articles/ac-mxnet-cbox-firmware Please update the CBOX first, before attempting updates on the ...
AC-MXNET-10G-TCVR-AVDM-B Firmware ~ V1.33 ~ 4/24/2024
NOTE: If your AC-MXNET-10G-TCVR-AVDM-B is not selectable to update in MENTOR, please see this Knowledge Base Article to determine what firmware you need to upload: ...