AC-MXNET-1G-DANTE-E Firmware

AC-MXNET-1G-DANTE-E ~ V1.17 ~ 9/18/24

NOTE: AC-MXNET-1G-DANTE-E V1.16 requires your AC-MXNET-CBOX to be updated to V2.55 / AC-MXNET-CBOX-B to V4.09 or later, or you may have issues with RS-232 transmissions. 

V1.17
  1. Added the ability to change the extracted audio processor's operational mode from normal operation to option "2", which delays extracted audio processing by 7 seconds upon a hot plug event. This is used to mitigate a specific issue where certain sources would lose extracted audio but HDMI audio output was still present after a timeframe of 12-48 hours. Use the CBOX command "config set device dspmode" to adjust. 
V1.16
  1. Fixed an issue where MCU commands would bleed out of the RS-232 port of the endpoint. 
  2. Added a 2ch audio description for the 1920x1200 canned EDID.
V1.15
  1. Fixed an issue where the audio processor's firmware information wouldn't populate correctly.
V1.14
  1. Fixed an issue where the USER EDID interface wouldn't write properly.
V1.13
  1. Added the ability to request HDCP 2.2 or do not request HDCP to the endpoint. 
V1.12
  1. Optimized the copy EDID from output process.
  2. Fixed an issue where a change in the source's audio format could result in a loud "popping" sound to occur.
  3. Added the ability to change the IP address of the Dante module. 


    • Related Articles

    • How To: USB bridge FW update for AC-MXNET-1G-E/AC-MXNET-1G-AVDM-E Versions V3.33 through V3.37.

      If a firmware update was already attempted via the CBOX, and the Encoder OLED is not turning on, or if you're experiencing issues during the update process, please call Technical Support for further assistance. What you'll need: A Windows Based PC A ...

    • AC-MXNET-1G-DANTE-DV2 ~ V4.00 ~ 9-17-2024

      NOTICE: Please update the CBOX first before attempting an update on any endpoints. Release Notes: V4.00 Initial Release. Firmware parity with DV2-C V3.00

    • AC-MXNET-1G-E / AC-MXNET-1G-AVDM-E ~ (ENCODER) ~ V3.45 ~ 09/18/24

      If you current encoder firmware is on version 3.33 -> 3.37, you must first follow this article here. NOTE: AC-MXNET-1G-E firmware V3.44 requires CBOX V2.55 or CBOX-B V4.09, or higher in order for RS-232 communication to function properly. Release ...

    • AC-MXNET-1G-DANTE-EV2 ~ V4.01 ~ 9/17/2024

      NOTICE: Please update the CBOX first before attempting an update on any endpoints. Release Notes: V4.01 Added the ability to change the extracted audio processor's operational mode from normal operation to option "2", which delays extracted audio ...

    • AC-MXNET-CBOX ~ V2.71 ~ 9/18/24

      NOTICE: If your CBOX is reading firmware as a version of V4.XX, please navigate to this page here: https://support.avproedge.com/portal/en/kb/articles/ac-mxnet-cbox-b-firmware Note: Please update the CBOX first, before attempting updates on the ...