AC-MXNET-1G-AVDM-EV2 Firmware Release

AC-MXNET-1G-AVDM-EV2 ~ V3.05 ~ 9/18/24

NOTICE: Please update the CBOX first before attempting an update on any endpoints.

Note: If your AC-MXNET-1G-AVDM-EV2 is showing firmware as V2.XX instead of V3.XX as listed here, use the latest firmware on this page: https://support.avproedge.com/portal/en/kb/articles/ac-mxnet-1g-ev2-b-firmware

Release Notes:
V3.05
  1. Added the ability to change the extracted audio processor's operational mode from normal operation to option "2", which delays extracted audio processing by 7 seconds upon a hot plug event. This is used to mitigate a specific issue where certain sources would lose extracted audio but HDMI audio output was still present after a timeframe of 12-48 hours. Use the CBOX command "config set device dspmode" to adjust. 
V3.04
  1. Added an internal communication path to allow the MCU to interface with the AVDM chipset. No other notable changes for this firmware release.

V3.03
  1. Adjusted the audio mute time when the ingested audio format changes to resolve an issue where switching audio formats would emit a static "pop" noise.

V3.02
  1. Fixed an issue where MCU commands could bleed out of the RS-232 port of the endpoint.
  2. Added a 2ch audio description for the 1920x1200 EDID.

V3.01
  1.       Fixed an audio dropout issue with Sky cable boxes, where audio would cut out every 20-30 minutes.

V3.00
  1.       Initial Release. Version change from AC-MXNET-1G-EV2-B to incorporate latest DSP chipset firmware.