This unit now supports OTA (over-the-air) firmware updating capabilities. This means that it can automatically detect newer versions of firmware from the Web UI once they are released and will prompt the update when Cloud Services are enabled.
Important Notes:
- Depending on the amount of firmware needed, the estimated update time is 2-5 minutes.
- Use a Chrome or Edge browser, the popup blocker in Firefox and Safari will stall the update page and
abandon the process.
- The OTA Firmware Update Guide is included in the box with every unit. A digital PDF copy of it can be
RELEASE DATE: 16 MAY 2023
FWM Version: 2.04.00.0.fwm
Date: 20230504
Enhancements:
- Added Auto-Switching, Priority Selection, and Input Fallback commands
- Default Fallback Input: OUTx AFB = Input 8
- If OUTx AFB IN changes from y8 to yX [X=1-8] then yX will replace y8 and all other y values will shift
up 1 priority
SET HDx AUTO EN/DIS
|
Set HDMI Output x to Auto Mode Enable
or Disable
{x=[0~4](0=ALL)}
|
SET OUTx PIN y
|
Set Output x Auto-Switch Mode Priority
Enable/Disable
{x=[0~4](0=ALL),y=[0-DIS,1-EN]}
|
SET OUTx PIN PTH yy
|
Set Output x Auto Switch Mode Priority
Path
{yy==y1.y2.y3.y4.y5.y6.y7.y8}
{x=[0~4]90=ALL),y1.y2.y3.y4.y5.y6.y7.y8=[1-8]}
|
SET OUTx AFB INy
|
Set Output x Auto-Switch Fallback Input
Port y
{x=[0~4](0=ALL),y=[0-8](0=Invalid
Port)}
|
GET HDx AUTO
|
Get HDMI Output x Auto Status
{x=[0~4](0=ALL)}
|
GET OUTx PIN
|
Get Output x Auto-Switch Mode Priority
Status
{x=[0~4](0=ALL)}
|
GET OUTx PIN PTH
|
Get Output x Auto-Switch Mode Priority
Path
{x=[0~4](0=ALL)}
|
GET OUTx AFB IN
|
Get Output x Auto-Switch Fallback Input
Port Status
{x=[0~4](0=ALL)}
|
- Added command to support 3rd party HDBaseT receivers: SET TP LK MODE
Bug Fixes
- H command table and web page deletion; command SET INx PWR ON/OFF & GET INx PWR
- Fixed an issue where some timings could lose video
- Added the Audio Input ports 5-8 to the CX84 Audio Matrix web page
- Fixed I/O Config tab issue where Extracted Audio EN/DIS and Mic EN/DIS were misrepresented